Audio dubbing
Monitoring the new recorded sound
To play back the sound
Adjust the balance between the original sound (ST1) and the new sound (ST2) by selecting AUDIO MIX in the menu settings (p. 89).
| VCR SET |
|
|
|
|
| EXIT |
| |||||
|
| H i F i SOUND |
|
|
| ||||||||
|
| AUD I O M I X |
|
|
|
|
|
|
| ||||
|
| A/VtDV OUT | ST1 |
| ST2 | ||||||||
|
|
|
|
|
|
|
|
|
|
| |||
| r |
|
| R |
|
| EXEC |
| RET. |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
About five minutes after when you disconnect the power source or remove the battery pack, the setting of AUDIO MIX returns to the original sound (ST1) only. The default setting is original sound only.
Notes
•New sound cannot be recorded on a tape already recorded in the
•New sound cannot be recorded on a tape already recorded in the LP mode. •You cannot add audio with the DV IN/OUT jack.
•New sound cannot be recorded on blank portions of the tape.
If you make all the connections
The audio input to be recorded will take precedence over others in the following order. •MIC (PLUG IN POWER) jack
•AUDIO/VIDEO jack
If an i.LINK cable (DV connecting cable) is connected to your camcorder You cannot add a sound to a recorded tape.
We recommend that you add new sound on a tape recorded with your camcorder If you add new sound on a tape recorded with another camcorder (including other
If you set the
You cannot record on a tape. Slide the
To add new sound more precisely
Press ZERO SET MEMORY at the point where you want to stop recording later in the playback mode.
Carry out steps 3 to 5. Recording automatically stops at the point where ZERO SET MEMORY was pressed.
80