The HKCU1001 consists of an EN-A front board and a VDA-A rear board.

When these boards are installed in the front and rear expansion slots of the unit, the unit outputs SD composite signals, waveform monitor output signals, and picture monitor output signals through the VDA-A board.

For details on installation, contact a Sony service or sales representative.

EN-A Board

EN-A

NTSC

1 SD signal format indicators

PAL

SC PHASE

ADV

2 SC PHASE switch

DELAY

aSD signal format indicatorsEither of these indicators lights, corresponding to the SD signal format.bSC PHASE (subcarrier phase) switchUsed to adjust the SC phase with respect to the reference signal (black burst).

Press and hold the switch towards ADV to advance the phase or towards DELAY for delay. The phase is advanced or delayed only while the switch is held pressed.

VDA-A Board

VDA-A

VBS 1

1VBS 1, 2 connectors

2

PIX

OUT

2 PIX OUT connector

WF

OUT

3 WF OUT connector

aVBS 1, 2 (composite video output 1, 2) connectors

(BNC-type)

The signal from the video camera may be output as two analog composite signals.bPIX OUT (picture monitor output) connector (BNC-type)

Outputs the video signal for a picture monitor selected with the PICTURE MONITOR button of an RCP-700/900 series Remote Control Panel or MSU-900 series Master Setup Unit.

Character signals or marker signals can be superimposed on the video signal output through this connector.

For details on these operations, refer to the Master Setup Unit or Remote Control Panel manuals.

cWF OUT (waveform monitor output) connector

(BNC-type)

Outputs the video signal for a waveform monitor selected with the WF MONITOR button of an RCP-700/900 series Remote Control Panel or MSU-900 series Master Setup Unit.

For details on these operations, refer to the Master Setup Unit or Remote Control Panel manuals.

HKCU1003 Multi Interface Unit (optional)

Note

To reduce the risk of electric shock, fire or injury, do not open the cabinet. To adjust the internal settings, refer to qualified service personnel.

The HKCU1003 consists of an EN-B front board and three VDA rear boards (A/B/C). Only the VDA-A board can actually be used with the HDCU3300 at present, and the HKCU1003 has almost the same function as the HKCU1001.

Note

The VDA-B board can be used, but the FRAME REF IN connector does not function.

For details on installation, contact a Sony service or sales representative.

40 Locations and Functions of Parts