hINTERCOM connector (XLR 5-pin)Connect a headset.

To use a headset with a plug other than an XLR 5-pin plug, consult a Sony service or sales representative.

Rear Panel

4 RETURN INPUT area

5 Ethernet connector

3 SUPER MOTION OUTPUT area

6 INPUT area

2 HD SDI OUTPUT area

7 Spare connector

1 SDI OUT area

8 OUTPUT area

 

9 CAMERA connector

SLOT3 SLOT2

HD SDI

SDI OUT OUTPUT

SLOT1

SUPER MOTION OUTPUT

CBA

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

w; AC IN connector

0 Expansion slots

 

 

 

qa INTERCOM/TALLY/PGM connector

 

 

ql MIC1, MIC2 connectors

qs MIC REMOTE connector

 

qk TRUNK A connector

 

 

7 Spare connectors

 

qj RCP/CNU connector

 

 

qd WF REMOTE connector

 

qh WF MODE connector

 

 

 

qf TRUNK LINE connector

qg I/O PORT connector

aSDI OUT area (BNC-type)The signal from the video camera may be output as two HD-SDI or SD-SDI signals.

The signals output from the SDI OUT 3 and SDI OUT 4 connector can be superimposed character and marker. SD-SDI signals are output only when the system is operating with a field frequency of 59.94/50 Hz.

For details on the field frequency setting, contact a Sony service or sales representative.

bHD SDI OUTPUT area (BNC-type)

The normal speed video signal from the video camera can be output as four HD-SDI signals.

cSUPER MOTION OUTPUT area (BNC-type)The HD super slow motion signals from the video camera can be output as two LINK-A, LINK-B or LINK-C signals. The connectors below are spares.

Note

The connectors in this area do not supply the color bar signals while the power to the video camera is ON (default setting). There is a setting on the setup menu to supply the color bar signals even if the power to the video camera is

ON. With that setting, the color bar signals are also supplied to the viewfinder on the camera.

For details on the setup menu, contact a Sony service or sales representative.dRETURN INPUT area1HD-SDI 1 to 4 (HD-SDI return video input 1/2/3/4) connectors (BNC-type)Four different HD-SDI return video input signals may be received independently.

The selection of RET 1, 2, 3, or 4 is made by the return switch of the video camera.

The type of input signal on RET 1, 2, 3, and 4 may be set individually using the setup menu, or using the MSU-900 series Master Setup Unit.

For details on the setup menu, contact a Sony service or sales representative.

Refer also to the Master Setup Unit manual.

Locations and Functions of Parts

37