2SD-SDI 1 to 4 (SD component SDI return videoinput 1/2/3/4) connectors (BNC-type)

Four different SD component SDI return video input signals may be received independently when the system is operating with a field frequency of 59.94/50 Hz.

The selection of RET 1, 2, 3, or 4 is made by the return switch of the video camera.

The type of input signal on RET 1, 2, 3, and 4 may be set individually using the setup menu, or using the MSU-900 series Master Setup Unit.

An aspect ratio may also be selected for SD signals.

For details on the setup menu, contact a Sony service or sales representative.

Refer also to the Master Setup Unit manual.

3VBS 1 to 4 (VBS return video input 1/2/3/4)connectors (BNC-type)

Four different VBS return video input signals may be received independently.

The selection of RET 1, 2, 3, or 4 is made by the return switch of the video camera.

The type of input signal on RET 1, 2, 3, and 4 may be set individually using the setup menu, or using the MSU-900 series Master Setup Unit.

An aspect ratio may also be selected for SD signals.

For details on the setup menu, contact a Sony service or sales representative.

Refer also to the Master Setup Unit manual.

eEthernet connector (RJ-458-pin)Reserved for future use.

CAUTION

For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port.

ATTENTION

Par mesure de sécurité, ne raccordez pas le connecteur pour le câblage de périphériques pouvant avoir une tension excessive à ce port.

ACHTUNG

Aus Sicherheitsgründen nicht mit einem Peripheriegerät- Anschluss verbinden, der zu starke Spannung für diese Buchse haben könnte.

fINPUT area1PROMPTER 1, 2 (teleprompter input 1, 2)

connectors (BNC-type)

Input a teleprompter signal to either of the two connectors. The input signal is output from the other connector as is (loop-through output). If loop-through output is not used, terminate the unused connector at 75 ohms. If the signal used is a 1.0 Vp-p, 75-ohm signal, it may be output from the PROMPTER OUT connector of the video camera with a frequency bandwidth of 5 MHz, regardless of signal format.

2REFERENCE connectors (BNC-type)

Input an HD tri-level reference sync signal or SD reference sync signal (black burst signal) to either of the two connectors.

The input signal is output from the other connector as is (loop-through output). If loop-through output is not used, terminate the unused connector at 75 ohms.

The type of reference signal is selected using the setup menu, or using the MSU-900 series Master Setup Unit.

For details on the setup menu, contact a Sony service or sales representative.

Refer also to the Master Setup Unit manual.

Note

To use the VBS signal of the HKCU1001 SD Encoder Unit or the HKCU1003 Multi Interface Unit (when SC phase lock is required), use an SD reference sync signal (black burst signal).

gSpare connector (BNC-type)Reserved for future use.

hOUTPUT area

1SYNC (sync signal output) connector (BNC-type)Used for output of an SD composite sync signal (with no burst signal) or an HD tri-level sync signal from the internal sync signal generator. (Factory setting: SD composite sync signal)

For details on the signal selection, contact a Sony service or sales representative.

2CHARACTER (character output) connector (BNC-type)

Outputs the self-diagnostic results or the setup menu as an SD monochrome analog video signal.

3AES/EBU connector (BNC-type)

Outputs an AES/EBU format digital audio signal input to a video camera.

38 Locations and Functions of Parts