Insert the “Memory Stick” into the slot so that the labeled side of the stick faces you.

When the “Memory Stick” is correctly set, the ACCESS indicator lights in green. If the indicator stays dark, the “Memory Stick” may be inserted incorrectly. Check the stick and reinsert it. To eject the “Memory Stick,” press it in.

Note

Do not eject a “Memory Stick” when the ACCESS indicator is lit in red (which means that data is being read from or written to the “Memory Stick”). This may erase data stored in the “Memory Stick.”

cEthernet indicator Reserved for future use.dREFERENCE indicators and switch

The switch is used to select the type of sync signal to be connected to either of the REFERENCE connectors on the rear panel.

HD: HD tri-level reference sync signal (local setting)RMT (remote): Signal selected on the MSU-900 series Master Setup UnitSD: SD reference sync signal (black burst signal) (local setting)

When a signal is supplied to the REFERENCE connector, the REF IN indicator lights. If the type of the input sync signal does not match the setting on this unit, the UNLOCK indicator will light.

eH PHASE switch Used to adjust the H phase.

Press and hold it towards ADV to advance the phase or towards DELAY for phase delay. The phase is advanced or delayed only while the switch is held pressed.

AVP Board
aCCU POWER indicatorLights when the power voltage inside the board is normal.bCAM LOCK (camera lock) indicatorLights when the transaction with the video camera is operating normally.cCAM POWER (camera power) switchPress downward to turn the video camera connected to this unit on or off.dSYSTEM indicators

/1.001 (frame frequency): Lights when the frame frequency of the camera system is set to 1/1.001.

LINE DELAY (phase difference): Lights when the phase difference between HD and SD outputs is set to LINE DELAY.

Phase difference is 90H when the scan line is 1125, or 120H when the scan line is 720.

e2WIRE CANCEL controls

When using a 2-wire intercom system, adjust the controls to minimize the side tone level on the producer line (PROD) and engineer line (ENG).

CPU Board

CPU

1 ACCESS indicator

2 “Memory stick” slot

AVP

CCU

1 CCU POWER indicator

POWER

CAM

2 CAM LOCK indicator

LOCK

 

CAM POWER

3 CAM POWER switch

ON/

 

OFF

 

SYSTEM

 

/1.001

4 SYSTEM indicators

LINE

 

DELAY

 

2WIRE CANCEL

PROD 5 2WIRE CANCEL controls

ENG

aACCESS indicator

Shows the status of the “Memory Stick.”

Indication

Meaning

Off

No “Memory Stick” is inserted.

 

 

Lit in green

There is a “Memory Stick” in the slot.

 

 

Lit in red

Data is being read/written. If you eject the

 

“Memory Stick” during this operation, the

 

integrity of the data is not guaranteed. All the

 

data may be lost.

 

 

44 Internal Switches and Internal Boards