000H: If there are no DATA2 and DATA3: A track currently being played or paused and the previous track are combined.

If there are DATA2 and DATA3: When in the STOP mode, a track specified by the DATA2 and DATA 3 and the previous track are combined.

001H: Starts rehearsal play for combining the tracks at the position where the two tracks will be joined. If there are DATA2 and DATA3, the rehearsal playback at the position where the track specified by DATA2 and DATA3 and the previous track will be joined starts.

002H: The tracks are combined at the rehearsed position

DATA2 (10, 1) DATA3 (**, 100)

Specify the track No. to be combined in the STOP mode.

Note

Sending this command in the PLAY mode could change the track numbers and may result in confusion. Therefore, operation should be performed in the PAUSE status.

RETURN command: None

MOVE

Command: 019H

Function : Moves a specific track to the desired position to change the order of play.

Issue this command in the STOP, PLAY or PAUSE mode.

DATA: 2 (4) DATA1 (10, 1)

DATA2 (**, 100) destination (001-255, decimal number)

DATA3 (10, 1)

DATA4 (**, 100) the track to be moved (001- 255, decimal number)

Notes

•If the MOVE command is executed in the PLAY or PAUSE mode, DATA: 2 is required.

Sending this command in the PLAY mode could change the track numbers and may result in confusion.

•If the MOVE command is executed in the STOP mode, DATA: 4 is required.

•This command is not accepted in the RECORD mode.

RETURN command: None

TRACK LOCATE

Command: 01AH

Function : Skips the tracks in forward or reverse direction.

DATA: 1 DATA1 000H: NEXT

001H: PREVIOUS RETURN command: None

TRACK No. LOCATE

Command: 01BH

Function : Locates a specific track. This command is used together with the “TRACK No. LOCATE POINT PRESET” (023H) command described below to locate a track preset by the 023H command.

Note

Although the deck does not provide this function, the devices used for recording or playback supports this function by operating the 10 keys on the remote controller.

DATA: None

RETURN command: None

TRACK No. LOCATE POINT PRESET

Command: 023H

Function : Specifies the track to be located.

This command is used together with the “TRACK No. LOCATE” (01BH) command listed above.

DATA: 2 (1)

DATA1 (10, 1) (*001 to 255, decimal number) DATA2 (**, 100)

DATA1=0FFH: TRACK No. LOCATE POINT SENSE

However, when DATA1 is 0FFH, TRACK No. LOCATE POINT SENSE becomes active to request the RETURN command 0A3H.

RETURN command: 0A3H

PGM TRACK No. PRESET

Command: 024H

Function : Selects the tracks for program play.

Appendix

Appendix A-13