Menu Setup 7 Chapter
LevelSync function adds track numbers automatically at specified points where the rise in the audio signal is detected during recording.
You can set the following items as well as turning on and off of LevelSync function using the setup menu for fitting your needs.
Turning on and off of the LevelSync function (F06: Levelsync)
The factory setting is off.
Threshold level for the LevelSync function (F16: Levelsync threshold)
You can adjust the threshold level for detecting as a silence portion of audio signal.
The minimum length of the silence portion to be detected (F17: Levelsync width)
You can set the minimum length of the silence portion to be detected. If the silence portion lasts longer than
1.5second, this portion is regarded as a track, and the track number will be marked when the following rise in the audio signal comes. You can adjust the minimum length to detect ranging from 0.0 second to
9.5seconds with reference to the input signals.
LevelSync offset function (F18: Levelsync offset)
The LevelSync offset function allows you to adjust the margin between the position where the track number is marked and the rise in the audio signal. You can tune finely the starting point of playback using this function.
You can shift up to 9 seconds 85 frames before or after the rise in the audio signal regarded as 0 second 0 frame (factory setting). However, you cannot mark the track number at the position before the silence portion starts.
|
| Silence portion |
|
| |||||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| |
Minimum length of the |
| Margin between the | |||||||
silence portion to be |
|
|
|
|
| track number position | |||
detected |
|
|
|
|
| and the rise in the | |||
Track number is | |||||||||
|
| audio signal | |||||||
|
|
|
|
|
|
|
marked here.
To set the items for the LevelSync function
| = + |
| 0 ) |
p (P | r |
1 | 2 – 5 |
1 Press the EDIT/NO button while holding down the STOP button.
The Setup menu appears.
2 Turn the AMS control until the item you want to set is displayed.
F06: Levelsync
F16: Levelsync threshold
F17: Levelsync width
F18: Levelsync offset
3 Press the AMS control.
The indication flashes to show that you can change the setting.
4 Turn the AMS control to select the setting values.
5 Press the AMS control to affect the selection and exit from the Setup menu.