To stop recording, flip the control bar towards x.

After you flip the bar towardsx to stop, the recorder wi (when using batteries) or about 3 m

To cancel synchro-recording

Turn the jog dial until“SYNC OFF” flashes in the display in step 3, and then press

Note

If you record on a previously recorded disc, the recorder is factory set to overwrite the entire contents of the disc. If you want the recording to start after the existing contents, do the procedure “Recording without overwriting existing material” (page 33) before doing step 3, “Record an MD.” (page 20).

ToPress

Record from the end ofIf “REC-Posi” (the record-starting position setting) is set to the current contents1) “From Here”, press END SEARCH, and then press and slide

REC to the right.1)

 

If “REC-Posi” is set to “From End”, press and slide REC to the

 

right.

 

 

 

Record over partway

Press N,., >orto find the st

through the previous

flip thextobarstoptowards.

recording1)

Then press and slide RE

Pause

2)

 

FlipX .the bar towards

 

Flip theXagbarintowardseume

Remove the MD x Flipand open3)the(Thebarthelidtoli

while“TOC Edit” flashing in the display.)

1)If “REC-Posi” is set to “From End”, recording operations will always start from the end of the previously recorded material without pressing the END SEARCH button (page 33).

2)A track mark is addedX atgainthe topointres pausing; thus the remainder of the

3)If you open the lid while “REC-Posi” is set to “From Here”, recording will begin from the top of the disc the next time you record. Check the point to start recording on the display.

If the recording does not start

•Make sure the recorder is not locked (pages 17, 72).

•Make sure the MD is not record-protected (pages 19, 75).

•Premastered MDs cannot be recorded over.

21