Labeling a track or a disc during recording
1 While recording, press EDIT for 2 seconds or more so that “EDIT” flashes in the display, and then press ENTER (x). “
: Name” flashes in the display.
2
3
To label a track, press ENTER (x) again.
To label a disc, press .or >Nrepeatedly until
“
: Name” flashes in the display, then press ENTER (x). The track or disc is ready to be labeled.
Follow steps 4 to 6 of “Labeling a disc during stop” (page 48).
To cancel labeling, press EDIT for 2 seconds or more or press
T MARK.
Note
When the recording is stopped while labeling a track or a disc during recording, or when the recording moves on to the next track while labeling a track, the input at that point is entered automatically.
Available characters
•Capital and small letters of the English alphabet
•Numbers 0 to 9
•! " # $ % & ( ) * . ; < = > ? @ _ ` + – ' , / : _ (space)
Relabeling recordings
Follow the steps corresponding to the labeling method until the disc or track is ready to be labeled. Enter a new character over the one you want to change, then press ENTER (xfor 2 seconds or more on the remote control).
Notes
•You cannot relabel premastered MDs or label MDs that have not been recorded.
•The recorder is able to display, but cannot label using Japanese “Katakana” characters.
•The recorder cannot rewrite a disc or track name of more than 200 letters that was created by another device.