2Record an MD
|
| REC |
END SEARCH |
x
1Press and slide REC to the right.
“REC” lights up and recording starts.
2Play the CD or tape you want to record.
To stop recording, press x.
After you press x, the recorder will automatically turn off in about 10 seconds (when using batteries) or about 5 minutes (when using AC power adaptor).
To | Press |
|
|
Record from the end of the previous | END SEARCH, and then press and slide |
recording1) | REC to the right. |
Record partway through the previous | Press jog lever (R) (N), or flip the jog |
recording1) | lever (R) towards > or .to find the |
| start point of recording and press xto stop. |
| Then press and slide REC to the right. |
|
|
Pause | X2) |
| Press Xagain to resume recording. |
|
|
Remove the MD | xand open the lid.3) (The lid does not open |
| while “TOC Edit” flashing in the display.) |
|
|
1)By setting
2)A track mark is added at the point where you press Xagain to resume recording while pausing; thus the remainder of the track will be counted as a new track.
3)If you open the lid while
If the recording does not start
•Make sure the recorder is not locked (page 55).
•Make sure the MD is not
•Premastered MDs cannot be recorded over.
For models supplied with the AC plug adaptor
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.
Notes
•“Data Save” or “TOC Edit” flashes while data of the recording (the track’s start and end points, etc.) is being recorded. Do not move or jog the recorder or disconnect the power source while the indication is flashing in the display.
•The lid does not open until “TOC Edit” disappears in the display.
•If the power supply is disrupted (i.e. the battery is removed or becomes exhausted or the AC power adaptor is disconnected) during a recording or editing operation, or while “TOC Edit” appears in the display, then it will not be possible to open the lid until power is restored.
17