If the following error messages flash in the display window, check the chart below.
Error message | Meaning/Remedy |
|
|
BLANKDISC | • An MD with no recording on it is inserted. |
|
|
DISC ERR | • The disc is damaged or does not contain proper recording or |
| editing data. |
| ,Reinsert the disc. If this fails, rerecord. |
|
|
DISC FULL | • There is no more space to record on the disc. |
| ,Replace the disc. |
|
|
Data Save | • The MD player is recording information (sounds) from the |
| memory to the disc. |
| ,Wait until this process is completed. Do not expose the player |
| to any physical shock, nor disrupt power supply. |
|
|
TOC Edit | • The MD player is recording information (track start and end |
| position) from the memory to the disk. |
| ,Wait until this process is completed. Do not expose the player |
| to physical shock, nor disrupt power supply. |
|
|
BUSY | • You tried to operate the recorder while it was accessing the |
| recorded data. |
| ,Wait until the message goes out (in rare cases, it may take a few |
| minutes). |
|
|
NAME FULL | • You tried to enter more than 200 letters to label a single track or |
| disc. |
| • You tried to enter a total of more than 1700 letters for track or disc |
| names. |
| ,Enter the characters within the limit. |
|
|
Hi DC in | • Voltage of the power supply is too high (The supplied AC power |
| adaptor or the recommended car battery cord is not used). |
| ,Use the supplied AC power adaptor or the recommended car |
| battery cord. |
|
|
HOLD | • The recorder is locked. |
| ,Slide HOLD against the arrow to unlock the recorder |
| |
|
|
LOW BATT | • Batteries are weak. |
| ,Charge the rechargeable battery or replace the dry battery |
| |
|
|
MEM OVER | • You tried to record with the recorder placed where it receives |
| continuous vibration. |
| , Put the recorder on a stable place, and start recording again. |
|
|
65