Recording without overwriting existing material

If you wish to avoid overwriting the current contents of an MD, do the following procedure. All new material will then be recorded from the end of the current contents.

Jog lever (L)

1 While the recorder is stopped, press the jog lever (L).

2 Flip the jog lever (L) repeatedly until “REC-Posi” flashes in the display, and then press the lever.

3 Flip the jog lever (L) repeatedly until “From End” flashes in the display, and then press the lever.

To start recording from the current point

Select “From Here” in step 3.

Notes

•The setting will remain even after the power is turned off.

•If you start recording while the recorder is in play-pause mode, the recording will begin from the point at which it is paused.

Recording from a microphone

Connect a stereo microphone to the MIC (PLUG IN POWER) jack. For more information on stereo microphones, see “Optional accessories” (page 69).

Stereo microphone

Jog lever (L)

REC

to MIC (PLUG IN POWER)

1 Press and slide REC to the right. For other operations, see “Recording an MD right away!” (page 16).

To stop recording, press x

To select microphone sensitivity

1Press the jog lever (L) while the recorder is stopped.

2Flip the jog lever (L) repeatedly until “MIC SENS” appears in the display, and then press the lever (L).

3Flip the jog lever (L) repeatedly until

“SENS HIGH” or “SENS LOW” appears in the display.

When recording a soft or a sound in the distance, set to “SENS HIGH”. When recording a loud or a sound at close range, set to “SENS LOW”.

4Press the jog lever (L).

25