5 While observing the level meter in the display, adjust the recording level by flipping the jog lever (L).

Set the level so that the input lights up around the fifth segment on the level meter. If the maximum input lights up the ninth segment, lower the level.

Volume

decreases increases

<,

REC+

fifth segment ninth segment

Recording does not start in this step. If your source is an externally connected component, be sure to cue the source to the beginning of the material to be recorded before you start playback.

6 Press Xagain to start recording.

To stop recording, press x.

The recording level control is switched back to automatic control when you record the next time.

z

If you press xduring recording operation, the recorder will revert to automatic recording level adjustment mode the next time you start a recording operation.

Notes

•The recording level cannot be adjusted while recording is in progress. If you want to adjust the recording level after you have started the recording, press Xto pause the recorder. Then do the procedure from step 5.

•You cannot adjust the recording level manually during synchro-recording.

Checking the remaining time or the recording position

You can check the remaining time, track number, etc. when recording or during stop.

On the recorder

Jog lever (L)

REC indicator

1 While the recorder is recording or stopped, press the jog lever (L), flip the lever until “DISPLAY” flashes in the display, and then press the lever again.

2 Flip the jog lever (L) until the information you want flashes in the display.

Each time you flip the lever, the display changes as follows.

LapTime (The elapsed time of the current track.)

r

RecRemain (The remaining recordable time.)

r

AllRemain (The remaining time after the current track.)1)

r

Clock (Current time.)

1)Appears only when the recorder is stopped.

3 Press the jog lever (L).

The display changes as follows.

28