BMD recording
Recording an MD right away! (Synchro- recording)
See the illustrations in English text (pages 16 and 17).
This section explains the basic procedure for making digital recordings using an optical cable connected to a CD player, BS tuner or other digital equipment. The recorder starts and stops recording in sync with the source sound. Track marks are added whenever they appear in the sound source. It is recommended to use the AC power adaptor when recording.
To record from a cassette deck, radio, etc. t“Recording in analog (Analog Recording)” (page 8)
To record using a group mode t “Recording tracks using the group function (Group Mode Recording)” (page 9)
1 Insert an MD.
1Press OPEN to open the lid.
2Insert an MD with the label side facing front, and press the lid to close.
Insert an recordable MD when recording.
2 Make connections. (Insert the cables firmly and completely into the appropriate jacks.)
1Connect the LINE IN (OPT) jack of recorder to the digital (optical) out jacks of the source with a optical cable.
The recorder switches to digital input automatically.
2Connect the DC IN 3V jack of the recorder to a wall outlet with the AC power adaptor.
When the recorder has different sound sources connected at the same time, the recorder switches to the digital, microphone, or analog input in this order of priority.
3 Record an MD.
1While the recorder is stopped, press the jog dial.
2Turn the jog dial until “SYNC REC” flashes in the display, and then press to enter.
3Turn the jog dial until “SYNC ON” flashes in the display, and then press to enter.
To cancel
4Press and slide REC to the right. “REC” and REC lamp on the REC switch light up and recording starts.
5Play the source you want to record.
To stop recording, press x.After you press x to stop, the recorder will automatically turn off in about 10 seconds (when using batteries) or about 3 minutes (when using AC power adaptor).
Note
If you record on a previously recorded disc, the recorder is factory set to overwrite the entire contents of the disc. If you want the recording to start after the existing contents, do the procedure “Recording without overwriting existing material” (page 10) before step 3, “Record an MD.” (this page).
To | Do this |
Record from the | If |
end of the | “From Here”, press END |
current | SEARCH, and then press and |
contents1) | slide REC to the right. |
| If |
| “From End”, press and slide |
| REC to the right. |
|
|
Record over | Press N, >, or . to |
partway through | find the start point of |
the previous | recording and press x to |
recording | stop. Then press and slide |
| REC to the right. |
|
|
Pause | Press X.2) |
| Press X again to resume |
| recording. |
|
|
Remove the MD | Press x, then press OPEN to |
| open the lid.3) |
1)If
5