En
ENGLISH
19

PLAY WITH DOLBY PRO LOGIC

1

Press VIDEO/A UX and start playback of the video

source.

VIDEO is displayed.
2

Press DOLBY PRO LOGIC.

NORMAL is selected, and the playback sound has the
DOLBY PRO LOGIC effect.
To cancel DOLBY PRO LOGIC mode
Press DOLBY PRO LOGIC repeatedly until OFF is displayed.
To change the sound levels during playback
After adjusting the balance with the noise sequencer , the sound
levels of the center or each surround speaker can be adjusted
during playback of laser discs or video software.
1Press MANUAL SELECT on the remote control repeatedly
to select CEN (center speaker) or SUR (surround speakers).
2While the CEN or SUR is displayed, press f DOWN or
g UP on the remote control to adjust the volume.

ADDITIONAL DOLBY PR O LOGIC MODES

In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 STEREO modes.
PHANTOM mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 STEREO mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
To select PHANTOM or 3 STEREO
Press DOLBY PRO LOGIC repeatedly until the desired DOLBY
PRO LOGIC mode is displa y ed. The DOLBY PR O LOGIC mode
is displayed cyclically as follows.
NORMAL PHANTOM
OFF
(
cancel
)
3 STEREO
T o adjust the balance of connected speaker sound le vels
Carry out steps 2 to 4 of ADJUSTING SPEAKER LEVEL
BALANCE.
Depending on the sound source and/or listening conditions, a
surround effect may not be obtained even when the DOLBY
PRO LOGIC is on.
The full DOLBY PRO LOGIC effect cannot be obtained when
using software without H mark.
The DOLBY PRO LOGIC is automatically canceled when:
- the ECHO level is changed.
- the BBE is tur ned on.
- the headphones are plugged in.
- the Karaoke function is turned on.
Set the microphone volume to OFF while the DOLBY PRO
LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound can
not be reproduced correctly.
DOLBY PRO LOGIC