14
ENGLISH

RECORDING

BASIC RECORDING

This section explains ho w to record from the tuner , CD pla yer , or
external equipment.
Preparation
•Use Type I (nor mal) tapes only.
• Set the tape to the point where recording will start.
• Note that recording is done on only one side of the tape.
1

Insert the tape to be recorded on into deck 2.

Insert the tape with the side to be recorded on first f acing out
from the unit.
2

Press function (CD, TUNER or VIDEO/AUX) and

prepare the source to be recorded.

To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from a connected source, press VIDEO/AUX.
3

Press w REC/REC MUTE to start recording.

When recording from a connected source, start playback of
the source.
When the selected function is CD, playback and recording
star t simultaneously.
To stop recording, press s.
To pause recording, press a. (Applicable when the source is
TUNER or VIDEO/AUX) To resume recording, press it again.
To start recording with the remote control
First press q REC/REC MUTE, and then press c/d within
2 seconds.
Sound adjustment during recording
The output volume and tone (except BBE) of the speakers or
headphones are freely varied without aff ecting of the recording.

INSERTING BLANK SPACES

Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/A UX.)
1 Press w REC/REC MUTE during recording or while in
recording pause mode.
4 on the displa y flashes for 4 seconds and 4-second b lank
space is made. Then, the deck enters the recording pause
mode.
2 Press a to resume recording.
To insert a blank space of less than 4 seconds, press w
REC/REC MUTE again while 4 is flashing.
To insert blank spaces of more than 4 seconds, after the deck
enters recording pause mode, press w REC/REC MUTE again.
Each time the button is pressed, a 4-second b lank space is added.
About cassette tapes
•To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
To record on the tape again, cover the tab openings with
adhesive tape , etc.
•120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
•Take up any slac k in the tape with a pencil or similar tool
before use. Slack tape ma y break or jam in the mechanism.
To erase a recording
Make sure the microphone is not connected to this unit. Set the
microphone volume and the echo level to OFF (see page 20).
1Insert the tape to be erased into dec k 2 and press T APE DECK
1/2 to display “TP 2”.
2Set the tape to the point where the erasure is to be started.
3Press w REC/REC MUTE to start the erasure.
•When recording an externally connected source via the VIDEO/
AUX jacks, the small dot near the 5 lights up continuously in
the display if the input level is too high.
In this case, stop recording and adjust the input level until the
dot lights intermittently (page 25).
•“Can’t REC” is display ed if you attempt to record on a tape with
the plastic tabs broken off.