i.LINK cable is connected: Disconnect the i.LINK cable from either this unit or the remote computer, wait for at least 10 seconds, and then reconnect the disconnected cable.

The unit is powered off and an i.LINK cable is connected: Power the unit on.

To disable FAM connections

Execute one of the procedures described in the previous section “To make a reconnection” to make a FAM connection between this unit and the remote computer. To disable FAM connections, in the setup menu, set INTERFACE SELECT >i.LINK MODE to “AV/C” (see page 71).

Recording ContinuousTimecode Over FAMConnections

For clips created over a FAM connection, you can record so that the timecode is continuous with the timecode of the last frame of the last clip recorded on the disc.

To record continuous timecode

Before you start recording, set TCG on page P2 of the function menu to “INT” and set TC MODE to “REGEN”. Then write clip files to this unit from a connected computer or other device.

Operations File 5 Chapter

64 Recording Continuous Timecode Over FAM Connections