Sony PDW-70MD Setup Menu Operations, Buttons used to change settings, Changing the settings of basic items

	INTERFACE SELECT [Interface]: Settings related to	Description
	interfaces
	REMOTE I/F [> Remote I/F]: Select how to perform remote	i.LINK [>> i.LINK]: Use the S400 connector.
	control, when the remote control switch is set to	*9PIN/RS-232C [>> 9P/232C]: Use either the REMOTE(9P)
	REMOTE.	*9PIN/RS-232C [>> 9P/232C]: Use either the REMOTE(9P)
	REMOTE.	connector or the RS232C connector, depending on the
		connector or the RS232C connector, depending on the
		setting of the remote connector selector switch.
		9PIN(PARA)[>> Para Run]: Use the REMOTE(9P) connector
		to connect several PDW-70MD units and perform remote
		control from one of them specified as the parent.

	BAUDRATE [> BaudRate]: Select the communications speed	*9600 [>> 9600]
	(bps) of the RS232C connector.	19200 [>> 19200]
		38400 [>> 38400]
		57600 [>> 57600]
		115200 [>> 115200]

	i.LINK MODE [> i.LinkMode]: Select the type of connection	*AV/C [>> AV/C]: AV/C connection.
	for the S400 connector.	FAM(PC REMOTE) [>> FAM]: FAM connection.
	for the S400 connector.


	METADATA [Metadata]: Metadata settings	Description
	INDEX POSITION [> Index Pos]: Specify which frame to use	0SEC [>> 0 sec] to 10SEC [>> 10 sec]: The frame at 0
	as the thumbnail image (index picture) when recording.	seconds to 10 seconds from the top of the clip, specified in
		units of 1 second.
		Factory default setting: *0SEC

	STORE OWNER [> Ownership]: Create UMID owner	The STORED OWNERSHIP screen appears.
	information.	For details, see Appendix “Setting UMID ownership
		For details, see Appendix “Setting UMID ownership
		information” on page 90.


	MENU GRADE [Menu grade]: Selection of menu items to	Description
	be displayed
	Determine whether to display basic items only or both basic	*BASIC [>> Basic]: Display basic items only.
	and enhanced items on the monitor screen and in the time	ENHANCED [>> Enhanced]: Display both basic and
	data display section when using the setup menu.	enhanced items.

6 Chapter

Setup Menu Operations

This section explains how to change menu settings.

Buttons used to change settings

Use the following buttons to change menu settings.

Menu control buttons	Functions
MENU button	•	Display and hide the menu.
	•	Return to the menu from
		setting screens.

M/MARK1 and m/MARK2	These buttons move the
buttons	highlighted cursor up and down
	within the current level to select
	an item or setting. Hold down
	one of these buttons to make
	the highlighted cursor move
	continuously.

Menu control buttons	Functions
</IN and ,/OUT buttons	Press the ,/OUT button to go
	down one level.
	Press the </IN button to go
	up one level.
	Hold down one of these
	buttons to make the highlighted
	cursor move continuously.

RESET button	•	Returns the setting to the
		factory default setting.
	•	Answer “No” to the question.

SET button	•	Saves the new setting in
		memory.
	•	Answer “Yes” to the question.

Changing the settings of basic items

The factory default setting is to display only the basic items. To change the settings of basic items, proceed as follows.

1 Press the M/MARK1 or m/MARK2 button to select the required item.

Menus

System Menu 71