This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING: THIS WARNING IS APPLICABLE FOR USA ONLY.

If used in USA, use the UL LISTED power cord specified below.

DO NOT USE ANY OTHER POWER CORD.

Plug Cap

Parallel blade with ground pin

 

(NEMA 5-15P Configuration)

Cord

Type SJT, three 16 or 18 AWG

 

wires

Length

Minimum 1.5 m, Less than 2.5

 

m (8 ft 3 in)

Rating

Minimum 10 A, 125 V

Using this unit at a voltage other than 120 V may require the use of a different line cord or attachment plug, or both. To reduce the risk of fire or electric shock, refer servicing to qualified service personnel.

WARNING: THIS WARNING IS APPLICABLE FOR OTHER COUNTRIES.

1.Use the approved Power Cord (3-core mains lead)/Appliance Connector/Plug with earthing-contacts that conforms to the safety regulations of each country if applicable.

2.Use the Power Cord (3-core mains lead)/Appliance Connector/Plug conforming to the proper ratings (Voltage, Ampere).

If you have questions on the use of the above Power Cord/Appliance Connector/ Plug, please consult a qualified service personnel.

When installing the installation space must be secured in consideration of the ventilation and service operation.

•Do not block the ventilation slots at the left side and right side panels, and vents of fans.

•Leave a space around the unit for ventilation.

•Leave more than 10 cm of space in the rear of the unit to secure the operation area.

When the unit is installed on the desk or the like, leave at least 0.5 cm of space in the left and right sides.

Leaving 5 cm or more of space above the unit is recommended for service operation.

The PDW-D1 is classified as a CLASS 1 LASER PRODUCT.

3