3-3 Power Preparations
This unit can be powered by a battery pack or AC power.
3-3-1 Using AC Power
Connect a power cord (not supplied, see page 58) to the AC power inlet connector (page 28) on the rear panel of the unit.
3-3-2 Using a Battery Pack
Usable battery packs
The battery packs usable with this unit are as follows.
To use a battery pack, the optional BKP- L551 battery adaptor is required.
Note
If the AC power supply and battery pack DC power supply are both present simultaneously, the unit operates from AC power.
To attach a battery pack
Refer also to the Installation Manual for the BKP- L551 battery adaptor.
Proceed as follows.
1 Using a Phillips screwdriver, remove the screws from the battery adaptor attachment section on the side panel of this unit.
2 Take out the hexagonal wrench from the back of the battery adaptor.
3 Using the hexagonal wrench, remove the attachment and battery spacer which are fixed to the back of the battery adaptor.
4 Using the hexagonal wrench, screw the battery adaptor to this unit, and connect the DC power cord to the DC power inlet connector on the rear panel of this unit.
Preparations 3 Chapter
33 |