Software Utility the Using 5 Chapter

•Device information menu

Basic information: Shows product information and system information (see page 49).

Hours Meter: Shows the cumulative number of operating hours of this unit (see page 49).

Version: Shows the firmware version information (see page 50).

Alarm log: Shows the alarms generated by this unit (see page 50).

•Setup menu

AV settings: Shows a window for setting the operation of this unit, time code, audio control, recording format, and line mode (see page 50).

Owner setting: Shows a window for setting UMID owner information (see page 53).

Battery mode setting: Shows a window for setting the alarm of remaining capacity of the battery pack in this unit (see page 54).

Save/recall setup: Shows a window for saving or recalling the AV, owner, and battery mode settings (see page 54).

Date/time setting: Shows a window for setting the date, time, and time zone (see page 54).

•Disc operation menu

Format: Shows a window for formatting a disc (see page 55).

Delete clip: Shows a window for deleting a clip or clips recorded on the disc (see page 55).

cOperating section

Shows the operating window for the function selected in the tree display.

Click the ? button to show help information on the display.

PC operation settings dialog box

In the menu bar, select Settings > PC operation settings, to open the PC operation settings dialog box.

In this dialog box, set the following items.

•Language used for the user interface of the utility software

•Enable/disable FAM connection

To set the language used

1 From the Language list, select the desired language, and click the Set button.

2 Exit the utility software, and restart it

(see page 46).

The language you selected in step 1 is now reflected in the utility software displays.

To enable or disable the FAM connection

1 In the FAM operation section, select either of the following for login, and click the Set button.

•Permit: Enable the FAM connection. (Select for an FAM connection.)

•Inhibit: Disable the FAM connection. (Select for an AV/C connection.)

2 Exit the utility software.

The new setting takes effect when exiting the utility software.

Notes

•If no FAM driver (see page 29) is installed in the connected computer, setting to “Permit” does not allow an FAM connection to be established. (The connection is always an AV/C connection.)

48 5-1 Starting and Exiting