Overview 1 Chapter
cViewfinder
dLid of the disc compartment
This opens when the EJECT button on the top panel is pressed. Press the side of the lid to close.
eAccessory fitting shoe
Attach an optional accessory such as a video light (see page 39).
fShoulder strap fitting
Attach the supplied shoulder strap (see page 38).
gViewfinder
Loosen this ring to adjust the
hViewfinder fitting shoe Attach the supplied viewfinder.
iFitting for optional microphone holder
Fit an optional
jLIGHT (video light) connector
A video light with a maximum power consumption of 50 W, such as the Anton Bauer Ultralight 2 or equivalent can be connected (see page 39).
kMIC IN (microphone input) (+48 V) connector
(XLR type,
Connect the supplied stereo microphone to this connector. The power (+48 V) is supplied via this connector.
lShoulder pad
Raise the shoulder pad fixing lever to adjust the position in the
For details of the adjustment, see “Adjusting the Shoulder Pad Position” on page 38.
1Video output and timecode connectors
1GENLOCK IN connector
GENLOCK
IN | TC IN |
VIDEO | TC |
OUT | OUT |
4 TC IN connector
3 TC OUT connector
2VIDEO OUT connector
aGENLOCK IN (genlock signal input) connector
(BNC type)
Input an SD or HD reference signal when applying a genlock to the camera, or synchronizing timecode to an external source. Use the GENLOCK page of the MAINTENANCE menu to carry out phase adjustment of the horizontal synchronization signal for genlock.
Note
The subcarrier phase cannot be adjusted.
bVIDEO OUT (video output) connector (BNC type) Outputs a video signal for a video monitor. The output signal is composite or HD Y. When the output signal is composite, setting menus, timecode, or shot data can be superimposed on the camera output video depending on the menu settings, and you can view them on the monitor screen. To lock the timecode of an external device to the timecode of this unit, connect the genlock signal input connector of the external device to this connector.
Notes
•The subcarrier phase cannot be adjusted.
•Even when you are recording or playing back HD 23.98P signals, 23.98PsF signals are not output from this connector. The output is 59.94i signals after
•Video signals are not output if the connection destinations of these connectors are not terminated properly.
You can select the composite or HD Y signal output on the OUTPUT page of the OPERATION menu. For details, see “Selecting the Output Signals” on page 141.
22 Location and Function of Parts