Overview 1 Chapter
Note
Do not remove a “Memory Stick” while the “Memory Stick” access indicator is lit. Doing so may cause a loss of data.
bDC IN (DC power input) connector (XLR type, 4- pin, male)
To operate the camcorder using an AC power supply, connect an
cAUDIO IN
selection switches
Connect other audio equipment or external microphone. Set the input selection switches as shown below according to the microphone or equipment.
LINE (left position): For connecting an external audio signal source such as a stereo amplifier
MIC (center position): For connecting any microphone other than 48 V microphone
MIC +48V ON (right position): For connecting a 48 V microphone
Signals input to the AUDIO IN
1)When the AUDIO IN
Note
If MIC +48V ON is selected for a microphone other than 48 V microphone, the microphone may be damaged.
d (i.LINK) DV OUT S400 connector
Connect to a device supporting the DV format or a computer, using an i.LINK cable (DV cable).
Notes
•If video and audio signals are not output from the
external device connected to the (i.LINK) DV OUT S400 connector, disconnect the i.LINK cable (DV cable) and then reconnect it, making sure that it is firmly seated.
•When you connect the camcorder and other equipment, such as a hard disk drive, with an i.LINK interface to a computer with i.LINK connectors, turn off the power of the computer, the other equipment, and the camcorder before connecting them using the i.LINK cable (DV cable). If a
1) Equipment that can be powered through i.LINK cable (DV cable)
eREMOTE connector
Connect an
Note
Before connecting/disconnecting the Remote Control Unit to/from the camcorder, be sure to turn off the camcorder POWER switch.
fDC OUT 12V (DC power output) connector
Supplies power for a
Do not connect any equipment other than the UHF synthesized tuner.
gAUDIO OUT connector (XLR type,
hSDI OUT connector (BNC type)
Outputs an HDSDI or SDI signal (with embedded audio). To switch between HDSDI and SDI output, use the SDI OUTPUT SEL item on the OUTPUT page of the OPERATION menu.
Note that when the selected signal format is HDSDI, this connector outputs no signal if you try to play back video recorded in the DVCAM format.
During recording and playback of HD 23.98P signals
You can select 59.94i signals after
24 Location and Function of Parts