WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL.

Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.

Section 810 of the National Electrical Code (NEC) in USA and Section 54 of the Canadian Electrical Code in Canada provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Antenna Grounding According to the NEC

Refer to section 54-300 of Canadian Electrical Code for Antenna Grounding.

❑ If liquid has been spilled into the set.

❑ If the set has been exposed to rain

or water. ❑ If the set has been subject to

excessive shock by being dropped, or the cabinet has been damaged.

❑ If the set does not operate normally when following the operating instructions. Adjust only those controls that are specified in the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a

qualified technician to restore the set to normal operation.

❑When the set exhibits a distinct change in performance, it indicates a need for service.

Replacement Parts

Ground clamp

Electrical service equipment

NEC: National

Electrical Code

Antenna lead-in wire

Antenna lead-in wire (NEC Section 810-20)

Grounding conductors (NEC section 810-21)

Ground clamps

Power service grounding electrode system (NEC Art 250 Part H)

When replacement parts are required, be sure the service technician certifies in writing that he has used replacement parts specified by the manufacturer that have the same characteristics as the original parts.

Unauthorized substitutions may result in fire, electric shock or other hazards.

Safety Check

Upon completion of any service or repairs to the set, ask the service technician to perform routine safety checks (as specified by the manufacturer) to determine that the set is in safe operating condition, and to so

Lightning

For added protection for this television receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the receiver due to lightning and power-line surges.

Service

Damage Requiring Service

Do not attempt to service the set by yourself since opening the cabinet may expose you to dangerous voltage or other hazards.

Unplug the set from the wall outlet and refer servicing to qualified service personnel under the following conditions:

❑ When the power cord or plug is damaged or frayed.

certify. When the set reaches the end of its useful life, ask a qualified service technician to dispose of the set.

For Safety

Be careful when moving the SXRD projection TV

When you place the SXRD projection TV in position, be careful not to drop it on your foot or fingers.

Watch your footing while installing the SXRD projection TV.

7