| Other Information |
|
|
Problem | Possible Remedies |
Cannot receive or select | ❏ Use Auto Program in the Channel menu to add receivable channels that are not |
channels | presently in SXRD projection TV memory (see page 116). |
|
|
Some digital cable channels are | ❏ Certain cable companies have limitations on the broadcast of digital cable |
not being displayed | channels. Check with your cable company for more information. |
| ❏ The digital cable channel may be set to Hidden in the Digital Setup menu (see |
| |
|
|
General
Problem | Possible Remedies |
How to reset TV to factory | ❏ Turn on the TV. While holding down the RESET button on the remote control, |
settings | press the POWER button on the TV. (The TV will turn itself off, then back on |
| again.) Release the RESET button. |
|
|
How to restore Video settings | ❏ Press RESET on the remote control while in the Video menu (see page 108). |
to factory settings |
|
|
|
How to restore Audio settings | ❏ Press RESET on the remote control while in the Audio menu (see page 112). |
to factory settings |
|
|
|
Cannot cycle through the other | ❏ Be sure the Label Video Inputs option is not set to Skip (see page 123). |
video equipment connected to |
|
the SXRD projection TV |
|
|
|
Cannot operate Menu | ❏ If a menu option appears in gray, this indicates that the menu option is not |
| available. |
|
|
Lost password | ❏ In the password screen (see page 118), enter the following master password: |
| 4357. The master password clears your previous password; it cannot be used to |
| temporarily unblock channels. |
| ❏ The i.LINK STANDBY LED blinks in red when the signal from an i.LINK device |
| is being shown. |
|
|
TIMER LED on front panel is | ❏ The LED (see page 26 or 137) blinks when the TV is turned on, then shuts off |
lit | when the picture is displayed. If the red LED blinks continuously, this may |
| indicate the TV needs service. When lit, indicates that the timer is set (see page 26 |
| or 137). When the timer is set, this LED will remain lit even when the TV is |
| turned off. |
|
|
POWER/STANDBY LED | ❏ If the LED blinks three times, the lamp cover may not be attached securely (see |
blinks in red | |
|
|
LAMP LED blinks in red | ❏ Replace the lamp (see page 20). |
|
|
The replacement lamp does not | ❏ The screw of the lamp cover may be slanted. Take out the screw, insert it straight |
light up | into the screw hole, and then tighten it completely (see page 20). |
|
|
Digital cable box does not work | ❏ If you are connecting a VCR and digital cable box using a splitter, as described on |
| page 42, you must use a special |
| with your digital cable box. Contact your cable provider for details. |
|
|
Cannot record digital channels | ❏ Only analog channels can be recorded to your VCR. |
to VCR |
|
|
|
Information Other
(Continued)
135