Adding an Extra Function to the Component Select Buttons (continued)
Example : To programme the input select signal of your amplifier to the CD button
1Place the
Remote control of your component
3While pressing the Mode Display key (LEARN), press the Component Select button or the Label key you want to “teach,” and release both keys.
(To change the Label keys, press the OTHER button repeatedly.)
The selected component name appears on the Mode Display key, and “LEARN” begins to flash.
about 2 – 4 inches |
|
(5 – 10 cm) away | |
|
2Follow Steps 2 and 3 on page 20 in “Learning Function.”
4Press and hold down the button on the component’s remote control (amplifier in this example) until you hear a beep.
(If you release the button before you hear a beep, the signal may not be learned correctly.)
“LEARN” stops flashing and stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and 4 again.
46