4Press PROGRAM + or PROGRAM – to search component code numbers in the same category (in this case, code numbers which begin with “8”).
Press PROGRAM + to go to the next code number.
Press PROGRAM – to go back to the
previous code number.
PROGRAM
6Press the ENT key.
A beep sounds, and the selected component name, the preset four- digit component code number and “OK” light for 2 seconds. And the display returns to Step 2.
Note
It is recommended to write down the code number.
7Press COMMANDER OFF.
COMMANDER
OFF
Note
To search component code numbers in another category, return to Step 3, or input a
5Aim the Commander at the component and press the POWER1key.
When the remote control signal is
sent,is shown on the display.
If it successfully works
If it doesn’t, repeat Steps 4 to 5.
If you keep COMMANDER OFF pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed for less than 2 seconds
The Commander returns to the previous set mode.
17