After Step 3, hold the Mode Display key pressed for more than 2 seconds. The Commander enter the Label Inputting mode.
Then follow the same procedure as that for changing the name of the Label key in Steps 2 - 5 on page 24.
To change the interval between timer operation stepsSee page 40.
Notes
•When using the timer setting on this Commander, only one setting can be assigned to one programme. If you want to set the timer to turn on at a programmed time, and to set the timer to turn off at another time, programme the two settings separately.
•If there are some programmes set to be executed at the same time, they start in order from the lowest programme number.
•According to the status of the component operated by the timer programme, the next programme might not function successfully. When setting a timer programme, check carefully the setting of other programmes.
Changing the programme already set or changing another programme that you select
1Follow Steps 1 - 3 on page 61, 62.
2Press the COPY key.
If you want to change the programme already set, go to Step 6 without pressing the COPY key.
The programme number appears on the left Label key, and “COPY” flashes on the right Label key.
3Press the COPY key repeatedly until the programme number of which contents you want to change appears. (Each time the COPY key is pressed, the programme number which has the timer setting information appears in order.)