Sony SLV-SF990G S21, Cleaning S22, Clock S23, Power S24, Power S25, S26, S27, S28, Tape S29, S30

Remote commander

S21	You cannot control	t Set your TV’s code number. The code number may change when you
	your TV.	replace the batteries for the remote commander (see page 9).
	Cleaning
S22	The VCR needs to be	t Clean the cabinet, panel and controls with a dry, soft cloth, or a soft
	cleaned.	cloth slightly moistened with a mild detergent solution. Do not use
		any type of solvent, such as alcohol or benzene.
	Clock
S23	The clock has	t The clock stops if the VCR is disconnected from the mains for more
	stopped and “–:– –”	than one hour. Reset the clock and timer if needed (see page 22).
	lights up in the
	display window.
	Power
S24	The ?/1 ON/	t Connect the mains lead to the mains securely.
	STANDBY switch
	does not function.
	Power
S25	The power is turned	t Moisture condensation has occurred. Turn the power off, unplug the
	on but the VCR does	mains lead and leave the VCR to dry for over three hours.
	not operate.
S26	The tape is ejected	t You have set a timer recording, but the tape on which you want to
	when you press ?/1	record is protected (or contains protected recordings). Unlock the
	ON/STANDBY.	protection or use another tape or replace the safety tab (see page 101).
S27	The display is not lit	t The VCR is in power save mode. Set the POWER SAVE option to
	when the VCR is in	OFF in the OTHER OPTIONS menu (see page 74).
	STANDBY mode.
S28	POWER SAVE is set	t The display is always lit if the VCR is in timer standby mode. For
	to ON but the display	more details regarding the energy saving function, see page 74.
	remains lit in
	STANDBY mode.
	Tape
S29	The tape is ejected	t You have set a timer recording, but the tape on which you want to
	when you press ?/1	record is protected (or contains protected recordings). Unlock the
	ON/STANDBY.	protection or use another tape or replace the safety tab (see page 101).
S30	A tape cannot be	t Check that a tape isn’t already in the tape compartment.
	inserted.
	SMARTLINK
S31	The SMARTLINK	t Check that your TV complies with SMARTLINK, NexTView Link,
	function does not	MEGALOGIC, EASYLINK/CinemaLink, Q-Link or TV-LINK.
	work properly.	t Make sure you use a 21-pin Scart cable to connect the VCR and your
		TV.
		t Make sure the Scart cable is connected securely. Refer to your TV
		manual for instructions.

108