Sony SLV-SF990G manual Using the shuttle ring, To use the shuttle ring in normal mode

Using the shuttle ring

With the shuttle ring, you can operate a variety of playback options. There are two ways for using the shuttle ring, normal mode and jog mode.

To use the shuttle ring in normal mode.

During playback or pause, turn the shuttle ring clockwise or anticlockwise. Each change in the shuttle ring position changes the playback mode, and the corresponding mark appears on the TV screen for a few seconds in the following way if the on- screen display function is on :

Playback mode:	Normal speed	Double speed		High speed
	(Initial speed)
Mark on the TV screen:			X 2

Slow motion	Pause	Slow motion
in reverse

High speed	Double speed		Normal speed
in reverse	in reverse		in reverse
		_ X 2		_ X 1

To use the shuttle ring in jog mode

Use this mode for frame-by-frame playback.

Press JOG to enter the jog mode. The JOG button lights up. If you change to the jog mode during any playback mode, the playback pauses so you can see a still picture. Each change in the shuttle ring position shifts the picture one frame. To shift frames in reverse, turn the shuttle ring anticlockwise. The frame shift speed depends on the speed you turn the shuttle ring. To resume normal mode, press JOG again. The JOG button turns off.

To resume normal playback

Press H (playback).

Tip

•Adjust the picture using the TRACKING +/– buttons if:

–Streaks appear while playing in slow motion.

–Bands appear at the top or bottom while pausing.

–The picture shakes while pausing.

To set tracking to the centre position, press both TRACKING buttons (+/–) at the same time.

Notes

•The playback sound is muted during the operations in the above table.

•In the LP mode, noise may appear or there may be no colour.

•If the playback mode mark doesn’t appear on the TV screen, press DISPLAY.

Operations Additional

Playing/searching at various speeds

61