Displays the date and time set on the camera.
You can set the date and time using the following two methods.
Note
When you purchased the camera, be sure to check the date and time of the camera and set them if necessary.
System (PC) current date timeDisplays the date and time set on your computer. Click Apply to transfer the computer’s date and time to the camera.
The set date and time are shown on Current date time.
Manual current date timeWhen you want to set the camera’s date and time manually.
Select the lower
Set the time difference from Greenwich Mean Time in the area where the camera is installed. When you send an
Select the time zone where the camera is installed from the
Notes
•If the time zone selected on the Time zone selecting menu is different from that set on the computer, the time is adjusted using the time zone difference and set on the camera.
•Due to the network properties, there may be a slight difference between the actual time and the time set on the camera.
Select the format of date and time to be displayed on the monitor image from the
You can select from among
Click Apply to transfer the setting to the camera.
Synchronization with NTP serverSynchronizes the camera's time with that of the NTP (Network Time Protocol) server.
Select On to activate the time synchronization, and Off to deactivate it.
NTP server name
Type the host name or IP address of the NTP server, up to 64 characters.
This setting is valid when the Synchronization with NTP server menu is set to On.
Interval time
Select the interval at which you want to adjust the camera's time referring to the NTP server' time, between 1 and 24 hours. The set interval is a guide, and does not indicate the exact time.
This setting is valid when the Synchronization with NTP server menu is set to On.
Note
The time adjusted by this function may be slightly in error depending on the network environments between the camera and the NTP server.
Camera the Administrating
Configuring the System — System setting Page | 19 |
|
|