6 Press V/v repeatedly to select “4 ohm” or “8 ohm” depending on the speakers you are using, then press to enter the selection.

7 Press MENU to exit the menu.

Notes

•If you are not sure of the impedances of the speakers, refer to the operating instructions supplied with your speakers. (This information is often on the back of the speaker.)

•When you connect all speakers with a nominal impedance of 8 ohms or higher, set “SP. IMPEDANCE” to “8 ohm.” When connecting other types of speakers, set it to “4 ohm.”

•When you connect front speakers to both the SPEAKER A and B terminals, connect the speakers with a nominal impedance of 8 ohms or higher.

–When you connect speakers with impedance of 16 ohms or higher in both “A” and “B” configuration:

Set “SP. IMPEDANCE” to “8 ohm” in the System Settings menu.

–For other types of speakers in other configurations:

Set “SP. IMPEDANCE” to “4 ohm” in the System Settings menu.

Selecting the front speaker

You can select the front speakers you want to drive.

SPEAKERS (OFF/A/B/A+B)

Press SPEAKERS (OFF/A/B/A+B) repeatedly to select the front speaker system you want to drive.

Note

You cannot switch the front speakers by pressing SPEAKER (OFF/A/B/A+B) when the headphones are connected to the receiver.

Set to To select

AThe speakers connected to the FRONT SPEAKERS A terminals.

BThe speakers connected to the FRONT SPEAKERS B terminals.

A+B

The speakers connected to both the

 

FRONT SPEAKERS A and B

 

terminals (parallel connection).

 

 

OFF

No audio signals are output from

 

any speaker terminals, or the PRE

 

OUT terminal.

 

 

Started Getting

39GB