Confirming/saving the measurement results
1 Confirm the measurement result.
When the measurement ends, a beep sounds and the measurement result appears on the display.
Measurement Display | Explanation | |
result |
|
|
|
|
|
When the | COMPLETE | Proceed to step |
measurement |
| 2. |
process |
|
|
completes |
|
|
properly |
|
|
|
|
|
When the | ERROR | See “When |
measurement | CODE XX | |
process fails |
| appear” (page |
|
| 43). |
2 Press V/v repeatedly to select the item, then press .
Item | Explanation |
RETRY | |
| calibration. |
|
|
SAVE EXIT | Saves the measurement |
| results and exits the setting |
| process. |
|
|
WRN CHECK | Displays a warning |
| concerning the |
| measurement results. See |
| |
| |
|
|
PHASE INFO | Displays the phase of each |
| speaker (in phase/out of |
| phase). See “When you |
| |
| (page 44). |
|
|
Item | Explanation |
DIST.INFO | Displays the measurement |
| result for speaker distance. |
|
|
LEVEL INFO | Displays the measurement |
| result for speaker level. |
|
|
EXIT | Exits the setting process |
| without saving the |
| measurement results. |
3 Press V/v repeatedly to select a preset number to be used, then press .
4 Press .
The measurement results are saved.
Tip
The size of a speaker (LARGE/SMALL) is determined by the low characteristics. The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the Speaker Settings menu (page 63). Save the measurement results first, then try to change the settings if you want.
When error codes appearTry the remedies and
Error code | Cause and remedies |
CODE 31 SPEAKERS (OFF/A/B/A+B) is set to OFF. Set it to others and re- perform the auto calibration.
CODE 32 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and re- perform the auto calibration. If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected.
CODE 33 (F) None of the front speakers are connected or only one front speaker is connected. The optimizer microphone is not connected.
continued
Started Getting
43GB