6 Press V/v repeatedly to select

9 Measurement starts.

“CAL TYPE,” then press

to

 

 

 

 

 

enter the parameter.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

7 Press V/v repeatedly to select the parameter, then press to enter the selection.

Calibration

Explanation

type

 

 

 

ENGINEER

Sets the frequency

 

characteristics to a set that

 

matches that of the Sony

 

listening room standard.

 

 

FULL FLAT

Makes the measurement of

 

frequency from each

 

speaker flat.

 

 

FRONT REF

Adjusts the characteristics

 

of all the speakers to match

 

the characteristics of the

 

front speaker.

8 Press V/v repeatedly to select “AUTO CAL START,” then press to start the measurement.

Measurement starts in five seconds. A countdown appears on the TV screen.

While the time is counting down, stand away from the measurement area to avoid measurement error.

42GB

The measurement process will take approximately 30 seconds. Wait until the measurement process completes.

Note

You cannot measure the speaker height of the surround speakers and the surround back speakers. Set this value from “SP POSI.” settings in the Speaker Settings menu (page 66).

Tips

•Operations other than turning the receiver on or off and pressing ON SCREEN to turn the display on or off are deactivated during auto calibration.

•When special speakers, such as dipole speakers are used, the measurements may not be performed correctly or auto calibration cannot be performed.

To cancel auto calibration

Auto calibration is cancelled when you change the volume, switch functions, change the speaker setting of the receiver, or connect headphones.