There is no sound, or only a very low- level sound is heard from the center/ surround/surround back speakers.
•Select a CINEMA STUDIO EX mode (page 72).
•Adjust the speaker level (page 74).
•Make sure the center/surround speaker (s) is (are) set to either “SMALL” or “LARGE” (page 64).
•Make sure the surround back speakers are set to “DUAL” or “SINGLE” (page 64).
There is no sound from the surround back speakers.
•Some discs have no Dolby Digital Surround EX flag even though the packages have Dolby Digital Surround EX logos. In this case, select “ON” in the “SB DEC MODE” (page 60).
There is no sound from the sub woofer.
•Check that the sub woofer is connected correctly and securely.
•Make sure you have turned on your speaker.
•When all speakers are set to “LARGE” and “Neo:6 Cinema,” or “Neo:6 Music” is selected, there is no sound from the sub woofer.
The surround effect cannot be obtained.
•Make sure the sound field function is on (press MOVIE or MUSIC).
•Sound fields do not function for signals with a sampling frequency of more than 48 kHz.
Dolby Digital or DTS
•Check that the DVD, etc. you are playing is recorded in Dolby Digital or DTS format.
•When connecting the DVD player, etc., to the digital input jacks of this receiver, make sure the setting for the digital audio output of the connected component is available.
Recording cannot be carried out.
•Check that the components are connected correctly (page 17, 23).
•Select the source component using INPUT SELECTOR (page 47).
The MULTI CHANNEL DECODING lamp does not light up in blue.
•Check that the playback component is connected on a digital jack and the input is selected properly on this receiver.
•Check whether the input source of the software being played back corresponds to the
•Check whether the setup on the playback component is set to
•Check whether the digital audio output of selected input is not assigned to another component input using DIGITAL ASSIGN function (page 86).
VideoThere is no picture or an unclear picture appears on the TV screen or monitor.
•Select the appropriate input on the receiver (page 47).
•Set your TV to the appropriate input mode.
•Move your TV away from the audio components.
•Assign the component video input correctly.
•The input signal should be same as input when you are
The source image input from the HDMI jack is not output from the receiver or the TV speaker connected to the receiver.
•Make sure that cables are correctly and securely connected to components.
•Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.
continued
Information Additional
103GB