Automatic tuning
If you don’t know the frequency of the station you want, you can let the receiver scan all available stations in your area.
1 Turn INPUT SELECTOR to select the FM or AM band.
The last received station is tuned in.
2 Press TUNING + or TUNING
Press TUNING + to scan from low to high; press TUNING – to scan from high to low. The receiver stops scanning whenever a station is received.
When the receiver reaches either end of the band
Scanning is repeated in the same direction.
3 To continue scanning, press TUNING + or TUNING – again.
Preset tuning
After you have tuned in stations using Direct Tuning or Automatic Tuning, you can preset them to the receiver. Then you can tune in any of the stations directly by entering its
Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations”.
Presetting radio stations
1 Turn INPUT SELECTOR to select the FM or AM band.
The last received station is tuned in.
2 Tune in the station that you want to preset using Direct Tuning (page 37) or Automatic Tuning (page 38).
3 Press MEMORY.
“MEMORY” appears in the display for a few seconds.
Do steps 4 to 5 before “MEMORY” goes out.
4 Press PRESET TUNING + or PRESET TUNING – repeatedly to select a preset station number.
Each time you press the button, the preset station number changes in the corresponding number and direction as follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
If “MEMORY” goes out before you press the preset station number, start again from step 3.
5 Press MEMORY again to store the station.
If “MEMORY” goes out before you can store the station, start again from step 3.
6 Repeat steps 2 to 5 to preset another station.
To change a preset number to another station
Do steps 1 to 5 to preset a new station to the number.
Tip
In Step 4, you can also use the remote to select a preset station number. Press SHIFT repeatedly to select a memory page (A, B or C) and then press the numeric button to select a preset number.