Performing several commands in sequence automatically (Macro Play) (continued)
Tip
If programming is unsuccessful, check the following:
–If the indicator does not light up in step 1, the batteries are weak. Replace both batteries.
–If the indicator lights 4 times in quick succession in step 3, an error has occurred. Start again from step 1.
To cancel programming
Press USE MODE during any step. The remote automatically exits the macro setting mode.
To delay the output of an IR code
Start over from step 1. In step 3,
•Press M1 (TV/SAT) when the macro setting is M1.
•Press M2 (TAPE) when the macro setting is M2.
1 second delay is programmed at this program step. The indicator lights twice slowly, then the remote automatically exits the macro setting mode.
To clear the programmed IR codes
Clear each macro step individually. In step 3,
•Press M1 (TV/SAT) when the macro setting is M1.
•Press M2 (TAPE) when the macro setting is M2.
The IR code is cleared. The indicator lights twice slowly, then the remote automatically exits the macro setting mode.
To start macro play
Press M1 (TV/SAT) or M2 (TAPE) while the ALT indicator turns ON.
Note
If the Macro Play function does not work properly, program a delay between each operation. See “To delay the output of an IR code”.