Broadcasts Receiving
SHIFT |
|
|
| ?/1 | FM MODE |
BAND |
|
|
| + | FUNCTION +/– |
PRESET +/– | – + |
| – | ||
| N | X | x |
|
|
| . > |
| + |
| |
| N | X | x | – |
|
.>
+ + +
– – –
Brief descriptions of buttons on the
remote used to receive broadcasts
PRESET +/– buttons: Press to select a preset station.
BAND button: Press to select the FM or AM band.
SHIFT button: Press to select a memory page (A, B, or C) for presetting radio stations or tuning to preset stations.
FUNCTION +/– buttons: Press repeatedly to select the tuner.
FM MODE button: If “STEREO” flashes in the display and the FM stereo reception is poor, press this button to improve the sound. “MONO” lights up in the display and you will not be able to enjoy stereo effect, but the sound will be less distorted.
Note
If “MONO” appears in the display even when the FM broadcast is received normally, press this button to turn off the “MONO” indication.
zWhen you tune to a station that provides RDS services
The program station name appears in the display.
Notes
•RDS may not work properly if the station you tuned to is not transmitting the RDS signal properly or if the signal strength is weak.
•After you disconnect the AC power cord of the receiver, RDS program station names may not be saved correctly. To prevent this, preset the RDS stations (page 19).
Manual Tuning
For details on the buttons and controls used in this section, see “Brief descriptions of buttons and controls on the receiver used to receive broadcasts” on page 17 and “Brief descriptions of buttons on the remote used to receive broadcasts” on this page.
1Press JOG MENU repeatedly until a component name appears in the display.
2Rotate the jog dial until “TUNER” appears in the display.
The last received station is tuned in.
3Press BAND to select the FM or AM band.
4Press TUNE MODE repeatedly until “MANUAL” lights up in the display.
5Rotate the jog dial.
Rotate the dial clockwise to increase the tuning frequency. Rotate it counterclockwise to decrease the tuning frequency.
When the receiver reaches the end of either band
Tuning starts over again in the same direction.
6If you tune in an AM station, adjust the AM loop antenna to optimize the reception.
7Repeat steps 3 to 6 to tune in another station.
zYou can change to the tuner quickly
Press BAND on either the receiver or the remote. Or press FUNCTION +/– on the remote repeatedly until “TUNER” appears in the display.
zIf you try to tune more precisely than is possible for the tuning scale
You won’t be able to tune in the exact frequency. The receiver scans frequencies in the following units:
FM: 50 kHz
AM: 9 kHz