Press BAND on either the receiver or on the remote. Or, press FUNCTION +/– on the remote repeatedly until “TUNER” appears in the display.
You can select the tuner quickly
z
To continue scanning, rotate the jog dial again.
6
Rotate the jog dial.
When you rotate the dial clockwise, the receiver scans from low to high; when you rotate it counterclockwise, the receiver scans from high to low.
When the receiver reaches either end of the band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is received.
5
Automatic Tuning
For details on the buttons and controls used in this section, see “Brief descriptions of buttons and controls on the receiver used to receive broadcasts” on page 17 and “Brief descriptions of buttons on the remote used to receive broadcasts” on page 18.
1 Press JOG MENU repeatedly until a component name appears in the display.
2 Rotate the jog dial until “TUNER” appears in the display.
The last received station is tuned in.
3 Press BAND to select the FM or AM band.
4 Press TUNE MODE repeatedly until “AUTO” lights up in the display.

Preset Tuning

For details on the buttons and controls used in this section, see “Brief descriptions of buttons and controls on the receiver used to receive broadcasts” on page 17 and “Brief descriptions of buttons on the remote used to receive broadcasts” on page 18.

Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations” below.

Presetting radio stations

1Press JOG MENU repeatedly until a component name appears in the display.

2Rotate the jog dial until “TUNER” appears in the display.

The last received station is tuned in.

3Tune in the station that you want to preset using Manual Tuning or Automatic Tuning (page 18 and this page).

4Press JOG MENU repeatedly until “Setup Menu” appears in the display.

5Rotate the jog dial until “Preset Memory” appears in the display, and press ENTER.

“MEMORY” lights up in the display for several seconds. Do steps 6 and 7 before “MEMORY” turns off.

6Rotate the jog dial to select the memory page and preset number.

The memory page appears and the preset number flashes. The memory page and preset number indication changes each time you rotate the jog dial as follows:

tA1yA2y...yA0yB1yB2y...yB0T￿

tC0y...yC2yC1T

To select the memory page quickly

Press SHIFT on the remote repeatedly.

If “MEMORY” turns off or preset number stops flashing before you select the memory page and preset number, start again from step 4.

Broadcasts Receiving

19GB