Using the Sleep Timer Z
You can set the receiver to turn off automatically at a specified time.
Press SLEEP on the remote while the power is on.
“SLEEP” lights up in the display.
Each time you press SLEEP, the time display changes as shown below.
t2:00 t 1:30 t 1:00 t 0:30 t 0:20 t 0:10 t OFF
After you specified the time, the display goes back the status before you pressed the SLEEP button.
To check the remaining time before the receiver turns off
Press SLEEP. The remaining time appears in the display.
To cancel the Sleep Timer
Press SLEEP again while the remaining time appears. “OFF” appears in the display and the Sleep Timer is canceled.
zWhen you turn on the i.LINK Control function (see this page)
When the receiver turns off, the corresponding i.LINK component turns off automatically at the same time.
Operations Other
Other Settings Using the Setup Menu
By using the i.LINK Control function, operations on the receiver can be automatically linked with the kperation of specific components.
Linking receiver operations with the operation of i.LINK components (i.LINK Control)
When i.LINK Control is turned on, the following operations are linked:
•When you press the CD N button or MD N button on the remote, the receiver and the corresponding component turn on and the component starts to play.
•When the N button on the CD player or MD deck is pressed to start playback, or the CD N button or MD N button on the remote of the receiver is pressed, the respective component is automatically selected as the program source.
•When the display brightness on the receiver is changed, the same change occurs to the brightness level of the displays on the
•When Sleep Timer turns off the receiver, the corresponding i.LINK component also turns off.
•When you turn the receiver on or off, the corresponding i.LINK component also turns on or off.
•When the i.LINK MD deck or CD player is selected and no operation has been done on the receiver for more than one minute, the receiver turns off automatically when you turn off the selected i.LINK component. However, when the Sleep Timer is activated, the receiver won’t turn off until the specified time elapses.
1Press JOG MENU repeatedly until “Setup Menu” appears in the display.
2Rotate the jog dial until “i.LINK Ctrl” appears in the display, and then press ENTER.
3Rotate the jog dial until “On” appears in the display, and then press ENTER.
To turn off the i.LINK Control function
Do the procedure above, selecting “Off” in step 3.
Notes
•The i.LINK Control functions described above may not work properly on certain components and under certain conditions.
•Make sure i.LINK Control is active on only one component within the i.LINK configuration. For example, when two STR- LSA1s are hooked up in the same configuration, turn on the i.LINK Control function on only one receiver and not the other.