Replacing the battery in the remote
Slide out and remove the battery case, and insert a new lithium battery CR2025 with the + side facing up. And then, slide the
battery case back in.
A lithium battery CR2025
1
2
1 Keep pushing.
2 Pull out.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard unused batteries according to the manufacturer’s instructions.
If you have any question or problem concerning your receiver, please consult your nearest Sony dealer.

WARNING Precautions

To prevent fire or shock hazard, do not expose the unit to rain or moisture.

To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.

On safety

Should any solid object or liquid fall into the cabinet, unplug the receiver and have it checked by qualified personnel before operating it any further.

On power sources

•Before operating the receiver, check that the operating voltage is identical with your local power supply. The operating voltage is indicated on the nameplate at the bottom of the receiver.

•The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.

•If you are not going to use the receiver for a long time, be sure to disconnect the receiver from the wall outlet. To disconnect the AC power cord, grasp the plug itself; never pull the cord.

•AC power cord must be changed only at the qualified service shop.

On placement

•Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.

•Place the receiver in a location with adequate ventilation to prevent heat buildup and prolong the life of the receiver.

•Do not place the receiver near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.

•The nameplate is located on the bottom exterior.

On operation

Before connecting other components, be sure to turn off and unplug the receiver.

On cleaning

Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine.

2GB