Recording
When recording to and from the i.LINK components, you don’t have to do any operations on the receiver. For details, refer to the operating instructions supplied with the playback and recording components.
Do the procedure below to record from a component connected to the ANALOG IN connectors or from the
1Select the component to be recorded.
2Prepare the component for playing.
3Insert a blank MD into the MD deck and adjust the recording level, if necessary.
4Start recording on the MD deck, then start playback on the playback component.
Note
While the MD deck is recording from a component connected to the ANALOG IN connectors or from the
Adjusting the Brightness of the Display Z
You can select one of three brightness levels for the display. The JOG MENU button can be turned off when a low brightness level is selected.
Press DIMMER on the remote while the power is on.
Each time you press DIMMER, the brightness of the display changes as follows:
v
The display is fully lit and the JOG MENU button is on.
v
The display lights up dimly and the JOG MENU button is on.
v
The display lights up dimly and the JOG MENU button is off.
v
The display and the JOG MENU button are both off.
zIf any change occurs in the display information while the display is turned off
The display turns back on (dimly) for several seconds to show the new information, and then turns off again.
zThe brightness level of the displays on the
The brightness level can be linked only when the i.LINK Control function is activated. For details, see page 26.
Operations Other