Sony RMPJHS1 Plug the AC power cord into a, Wall outlet Picture to fit the screen, Adjuster

1-6

Connectionsand Preparations	1	ON/	6	Adjust the size and position of
		Plug the AC power cord into a
		wall outlet.		the picture to fit the screen
		The ON/STANDBY indicator lights in red and		using the zoom lever and
		the projector goes into standby mode.		adjuster.
		STANDBY		Move the zoom lever to adjust the picture size.
		Lights in red.

When projecting from		When projecting from
the side		the center
	Screen	Screen
		Picture
Picture

7

Adjust to correct the trapezoidal distortion.

When projecting from the side Corrects the horizontal distortion. Press SIDE SHOT + or – so that the top edge of the picture becomes parallel to the bottom edge. If the left side is longer than the right side, press SIDE SHOT –.

Connections and Preparations

2	Press the @/1 (on/standby)
	switch to turn on the projector.
	The ON/STANDBY indicator lights in green.
	ON/
	STANDBY
	Lights in green.

3	Turn on the equipment
	connected to the projector.
	Refer to the operating instructions of the
	connected equipment.
4	Press INPUT to project the
	picture on the screen.
	Each time you press the button, the input
	indication changes. (1 page 15)

Zoom lever

Use the adjuster to adjust the picture position. Hold down and slide the adjuster stopper to the right, move the projector, then replace the stopper.

Adjuster stopper

You can move the projector vertically and horizontally within the following ranges:

If you position the projector on the left side of the screen, adjust so that the left side of the picture fits the left side of the screen. For the projector positioned on the right side, adjust so that the right side of the picture fits the right side of the screen.

If you position the projector below the bottom of the screen, adjust so that the bottom edge of the picture fits the bottom edge of the screen. For the projector positioned above the bottom of the screen, adjust so that the top edge of the picture fits the top edge of the screen.

Use SIDE SHOT + if the right side is longer.
To fine-adjust the distortion, press M or m.
When projecting from the center
Corrects the vertical distortion.
Use the menu. Select V (vertical) with the
KEYSTONE DIR setting in the INSTALL
SETTING	menu. Next, adjust with the
DIGIT KEYSTONE setting so that the left side
of the picture becomes parallel to the right side.

VIDEO 1

INPUT

Up to 20° each for horizontal angle

5	Adjust the focus roughly using
	the focus lever.	Up to 10° each for	Up to 2° each for
		vertical angle	tilting angle

VPL-HS1			Focus lever
	GB	10	Step 3: Adjusting the Picture Size and Position

(1 page 20)

If the top edge of the picture is longer than the

bottom edge, set to a plus value.

	If the bottom edge is longer than the top edge,
	set to a minus value.
8	Adjust the focus again using
	the focus lever.

Step 3: Adjusting the Picture Size and Position 11 GB