6 Remove the lens hole cover of VPL-FE40L/ FX40L/FX41L/FW41L.

7 Remove two lens caps and the lens connector cover from the replacment lens.

Adjust the lens so that the motor section faces up as in illustration , and check that the cushion around the lens is positioned as in illustration . Then insert the lens straight in the direction of the arrow.

Motor section

Lens connector cover

Face this side of the cushion down.

Notes

•If the cushion is not positioned as in illustration

,rotate it by hand. In this case, take care that the cushion does not come off the groove of the lens.

•Change the lens carefully so as not to damage the lens glass with the lever or other parts.

8 Move the lens fixing lever down to the bottom correctly.

If the lens fixing lever does not move down, the lens may not be fully inserted. Insert it again and move the lens fixing lever down to the bottom correctly.

Note

If the lens does not go in fully, turn the lens slightly right and left slightly.

9 Insert the tab on the rear of the front panel and the plug-in part into the main unit, then hold down the panel so it locks with a click.

Notes

•Take care not to allow the safety wire to protrude.

•After fitting the left and right front panels, check that the top of the front panel does not lift up or protrude from the main unit.

Note on changing lenses

Do not touch the surface of the lens.

Note

When you use the VPLL-1008, do so in the range between +90° and –90° (when the lower parts of the lens is a plus) on the basis of installing the VPL-FE40/ FX40/FX41/FW41 horizontally on the floor.

For Dealer

The VPLL-1008 is the lens for rear projection (optical axis angle: 0 degree). When using the VPLL-1008, you should install the projector with the center of the lens aligned with the center of the screen in the horizontal/vertical direction. If you do not do so, a portion of the picture may be invisible.

Also, after installing the lens, we recommend to set “Lens Control” in the Installation menu to “Off”.

13