“Installing the Projector and a Screen” (1 page 9).

3Move the projector vertically so that the bottom side of the picture fits the bottom inside of the screen frame.

5Adjust to correct horizontal trapezoidal distortion using the SIDE SHOT + or – .

SIDE SHOT

and Connections Preparations

Adjust so that the bottom side of the picture fits the bottom inside of the screen frame.

When adjusting the picture height, do not use the adjuster (1 page 20), but move the projector or the screen vertically to adjust so that the bottom side of the picture fits the bottom inside of the screen frame.

4Move the projector horizontally to the left or right so that one side of the picture fits the inside end of the screen frame.

Adjust so that one side of the picture fits the inside end of the screen frame.

If you position the projector on the left side of the screen, adjust so that the left side of the picture fits the left inside end of the screen frame. With the projector positioned on the right side, adjust so that the right side of the picture fits the right inside end of the screen frame.

Note

When adjusting so that one side of the picture fits the inside end of the screen frame, make sure not to separate the bottom side of the picture from the bottom inside of the screen frame.

Press SIDE SHOT + or – so that the upper side of the picture becomes parallel to the bottom side. If the right side is longer than the left side, press SIDE SHOT +. If the left side is longer than the right side, press SIDE SHOT –. To fine- adjust the distortion, press M or m.

Note

Even when projecting using “Side Shot”, four sides of a picture may sometimes not be parallel to the sides of a screen frame.

When projecting using both “Side Shot” ( 1 page 35) and “V Keystone” (1 page 35) adjustments

When projecting using both “Side Shot” and “V Keystone” adjustments, the vertical and horizontal distortions are corrected.

1Check that “V Keystone” in the INSTALL SETTING menu is set to “Auto."

Note

“V Keystone” in the INSTALL SETTING menu is set to “Auto” in the default. If it is set to “Auto,” the vertical distortion of the picture will be automatically corrected. The “V Keystone” adjustment may not correct trapezoidal distortion perfectly, depending on the room temperature or the screen angle. In this case, set manually by value adjustment.

Step 3: Adjusting the Picture Size and Position

21 GB