Sony VPL-PX21 Cleaning the Air Filter, Disposal of used projector lamp, Notch

Close the lamp cover and tighten the screw. Turn the projector back over.

6

7

8 Connect the power cord and turn the projector to the standby mode.

9 Press the following keys on the control panel in the following order for less than in five seconds each: RESET, <, ,, ENTER.

Notes

•Be sure to use the LMP-P201 Projector Lamp for replacement. If you use lamps other than LMP-P201, the projector may cause a malfunction.

•Be sure to turn off the projector and unplug the power cord before replacing the lamp.

•Do not put your hands into the lamp replacement spot, or not fall any liquid or object into it to avoid electrical shock or fire.

Disposal of used projector lamp

As the materials used in this lamp are similar to those of a fluorescent lamp, you should dispose of a used projector lamp in the same way as a fluorescent lamp.

Cleaning the Air Filter

The air filter should be cleaned every 300 hours.

When it becomes difficult to remove the dust from the filter, replace the filter with a new one.

To clean the air filter, follow the steps below:

1 Turn off the power and unplug the power cord.

2 Remove the air filter cover while holding down the air filter cover button on the filter cover.

Maintenance

3 Peel off the air filter. (The air filter is secured with Velcro tape (3).)

4 Remove the dust from the filter with a vacuum cleaner.

5 Install the air filter as shown in the figure. Install the air filter cover on the projector.

Notch

Notes

•Just placing the air filter on the Velcro tapes will not lock the air filter in place. When installing the air filter, place it on the air filter cover and attach by pressing down hard on the three Velcro tapes. Make sure that the air filter is not bent.

•Set the air filter correctly (straight) in the air filter cover. If the air filter is not straight, the filter may malfunction.

•If the air filter is excessively dirty, wash it with a mild detergent solution and dry it in a shaded place. If the dust cannot be removed, replace the air filter with the supplied new one.

•The air filter has front and back sides. Make sure you install the air filter in the right direction. Check the notch on the filter as shown in the figure above and install properly.

•Be sure to attach the air filter cover firmly; the power will not be turned on if it is not closed securely.

Maintenance

33 (GB)