Sony VPL-VW11HT Connecting with a VCR/15k RGB/ Component/Progressive Component Equipment, Connecting, projecting, and up Setting

Connecting

When making connections, be sure to:

•turn off all equipment before making any connections.

•use the proper cables for each connection.

•insert the plugs of the cables properly; plugs that are not fully inserted often generate noise. When pulling out a cable, be sure to pull it out by the plug, not the cable itself.

Connecting

Left side

CONTROL S IN	VIDEO IN
PLUG IN POWER	S VIDEO	VIDEO
TRIGGER			INPUT A
	G/Y	B/CB/PB	R/CR/PR SYNC/HD	VD
REMOTE			INPUT B
RS-232C	G/Y	B/CB/PB	R/CR/PR SYNC/HD	VD
(FOR SERVICE USE)

and up Setting

Connecting with a VCR/15k RGB/ Component/Progressive Component Equipment

This section describes how to connect the projector with a VCR, external active speakers, and 15k RGB/ component/progressive component equipment.

Also refer to the instruction manuals of the equipment to be connected.

Left side

to RGB/ component/ progressive component output

Pin Cable (not supplied)

Active speakers

projecting

CONTROL S IN	VIDEO IN
PLUG IN POWER	S VIDEO	VIDEO
TRIGGER			INPUT A
	G/Y	B/CB/PB	R/CR/PR SYNC/HD	VD
REMOTE			INPUT B
RS-232C	G/Y	B/CB/PB	R/CR/PR SYNC/HD	VD
(FOR SERVICE USE)

S-Video cable	Video cable
(not supplied)	(not supplied)

Active speakers

to S video	to video
output	output
VCR

15k RGB/Component equipment

Notes

•Set the aspect ratio using ASPECT in the INPUT SETTING menu according to the input signal.

•To connect a 15k RGB/component/progressive component equipment, select the COMPUTER/ COMPONENT/DTV YPBPR/DTV GBR in the INPUT-A or INPUT-B in the SET SETTING menu according to the input signal.

For details on setting, see page 27 (GB).

•You can connect a high definition equipment. The connection method is the same as above.

15 (GB)