The SET SETTING Menu

The SET SETTING menu is used for changing the settings of the projector.

SET SETTING

INPUT-A

 

STATUS:

ON

INPUT-A:

COMPONENT

INPUT-B:

COMPONENT

LANGUAGE:

ENGLISH

POWER SAVING:

OFF

SIRCS RECEIVER:

FRONT&REAR

CINE MOTION:

AUTO

STATUS (on-screen display)

Sets up the on-screen display.

ON: Shows all of the on-screen displays.

OFF: Turns off the on-screen displays except for the

menus, a message when turning off the power, and warning messages.

INPUT-A

Selects the computer, component, DTV YPBPR or DTV GBR signal input from the INPUT A connectors.

Note

If the setting is not correct, “Please check INPUT-A setting.” appears on the screen and the color of the picture becomes strange or the picture is not displayed.

INPUT-B

Selects the computer, component, DTV YPBPR or DTV GBR signal input from the INPUT-B connectors.

Notes

•If the setting is not correct, “Please check INPUT-B setting.” appears on the screen and the color of the picture becomes strange or the picture is not displayed.

•Set the progressive component signal, e.g. DVD, to “COMPONENT”; 15k RGB signal, e.g. game machines, to “DTV GBR.”

The SET SETTING Menu

The signals that can be output for each setting of INPUT-A and -B are as shown below.

Signal

 

Setting of INPUT -A and -B

COMPUTER COMPONENT DTV YPBPR

DTV GBR

 

15k RGB

–

–

–

 

(DVD output in

 

 

 

 

PAL system, etc.)

 

 

 

 

Component

–

 

 

–

Progressive

–

 

 

–

Component

 

 

 

 

(Progressive

 

 

 

 

DVD output etc.)

 

 

 

 

DTV (Digital BS

–

–

 

 

output, etc.)

 

 

 

 

Computer

 

–

–

–

 

 

: can be output

– : cannot be output

LANGUAGE

Selects the language used in the menu and on-screen displays.

Available languages are: English, French, German, Italian, Spanish, Japanese and Chinese.

POWER SAVING

When set to ON, the projector goes into the power saving mode if no signal is input for 10 minutes. The power saving mode is canceled when a signal is input or any key is pressed.

SIRCS RECEIVER

Selects the remote control detectors (SIRCS receiver) on the front and rear of the projector.

FRONT & REAR: Activates both the front and rear detectors.

FRONT: Activates the front detector only.

REAR: Activates the rear detector only.

CINE MOTION

Selects either position according to the signal source for the NTSC3.58/4.43, 15k RGB (60 Hz) or 525/60 signal.

AUTO: Set to AUTO when the input signal is from a film-originated material. 2-3 pull down is applied.

OFF: 2-3 pull down is not applied.

Note

This function will not operate for signals of 50Hz.

27 (GB)