Location and Function of Controls

Front/Left Side

3 21 8

45 ￿ 7

6

Rear/Right Side/Bottom

09

qa

qs qd

qf

Location and Function of Controls

1Zoom ring

Adjusts the size of the picture.

2Focus ring

Adjusts the picture focus.

3Ventilation holes (exhaust)

4Lens

Remove the lens cap before projection.

5Front remote control detector (SIRCS receiver)

6Adjusters

When a picture is projected on the out of the screen, adjust the picture using these adjusters.

For details on how to use the adjusters, see “How to use the adjuster” on page 10 (GB).

7Connector panel

For details, see page 12 (GB).

8Control panel

For details, see “Control panel” on page 11 (GB).

9AC IN socket

Connects the supplied AC power cord.

0Rear remote control detector (SIRCS receiver)

qa Lamp cover

qs Rear adjusters

qd Ventilation holes (intake)/air filter

About ventilation holes

Notes

•Do not place anything near the ventilation holes as it may cause internal heat build-up. Do not put your hand near the ventilation holes, or you may be burned.

•To detect clogs accurately, reset the air filter the first time you use the projector, and every time when you

replace the air filter.

•Replace and reset the air filter when a warning message is displayed on the screen to ensure optimal performance. This air filter cannot be cleaned. You should also reset the air filter when you use the projector for the first time.

For details, see “Replacing the Air Filter” on page 35 (GB).

qf Adjuster buttons

9 (GB)