Sony VPL-VW11HT Connecting with a Computer, When connecting with a computer

Connecting

Connecting with a Computer

This section describes how to connect the projector to a computer.

Select the “COMPUTER” in the INPUT-A or INPUT-B of the SET SETTING menu.

Notes

•This unit accepts the VGA, SVGA, XGA or SXGA signals. However, we recommend you to set the output signal of your computer to the XGA.

•If you set your computer, such as a notebook type IBM PC/AT compatible, to output the signal to both the display of your computer and the external monitor, the picture of the external monitor may not appear properly. In such cases, set the output mode of your computer to output the signal only to the external monitor.

For details, refer to the operating instructions supplied with your computer.

•Connect all the connecting cables to the INPUT A connector when you input a signal from the INPUT A connector.

Connect all the connecting cables to the INPUT B connector when you input a signal from the INPUT B connector as well.

When connecting with a computer

Left side

CONTROL S IN	VIDEO IN
PLUG IN POWER	S VIDEO	VIDEO
TRIGGER			INPUT A
	G/Y	B/CB/PB	R/CR/PR SYNC/HD	VD
REMOTE			INPUT B
RS-232C	G/Y	B/CB/PB	R/CR/PR SYNC/HD	VD
(FOR SERVICE USE)

Conversion plugs1)

Monitor cable SMF-400 (not supplied)

Speakers

to monitor out

Computer

Note

When you connect with a Macintosh computer, you need an optional signal adapter.

.............................................................................................

1)When connecting INPUT A or INPUT B connectors on the projector, you need conversion plugs.

16 (GB)